Ricoh B205 Service Manual page 136

PHOTOCONDUCTOR UNIT (PCU)
10. Remove the development roller [A]
from the development unit.
Important: At reinstallation, make sure
that the mylar is positioned as shown.
11. Turn the development roller gear [B] to
remove toner from around the
development roller.
12. Assemble the development unit.
Important
• Dispose of the used developer according
to the local laws and regulations
regarding the disposal of such items.
13. Open the developer pack [C]
14. While turning the black gear [D], slowly
move the pack left and right and pour
half of the developer over the augur [E].
15. Continue to rotate the black gear until
the developer is level.
16. While continuing to turn the black gear,
slowly move the pack left and right and
pour the remaining half of the
developer over the augur until the
developer is level.
Important
• Be careful. Do not spill developer on the
gears or sponges.
• If you accidentally spill developer on the
gears or sponges, remove it with a
magnet or the tip of a magnetized
screwdriver.
B205/B209/D007/D008
[A]
[B]
[D]
[F]
3-24
[C]
[E]
SM