Ricoh B205 Service Manual page 353

Please keep the following important points in mind when you are doing this setting:
• Note that the number entries for Keys 1 to 5 are the same for the Copy, Printer,
Scanner, and Web memory modules.
• The initial settings are all zero.
• These settings remain in effect until you change them. Be sure to check all the
settings, especially the settings for Keys 6 to 10. To switch off a key setting,
enter a zero for that key.
• You can select any number of keys from 1 to 10 (or all) by entering the
corresponding 4-digit numbers from the table.
• You cannot mix settings for the groups (COPY, PRINTER, etc.) for 006~010. For
example, if you want to create a PRINTER debug log you must select the
settings from the 9 available selections for the "PRINTER" column only.
• One area of the disk is reserved to store the debug log. The size of this area is
limited to 4 MB.
SM
USING THE DEBUG LOG
5-139 B205/B209/D007/D008