Ricoh B205 Service Manual page 861

19. Connect the machine power cord and turn the main power switch on.
20. Enable the NIB and/or USB function.
•
To enable the NIB function, enter the SP mode and set SP5985-001 (On
Board NIC) to "1" (Enable).
•
To enable the USB function, enter the SP mode and set SP5985-002 (On
Board USB) to "1" (Enable).
21. If there was no HDD in the machine before you installed:
• Printer Enhance Option
• Printer Unit
• Printer/Scanner Unit
(1) Do SP5846 41 so the user can use the address book.
(2) Do SP5853 to copy the preset stamp data to the hard disk. Then turn the
main power switch off/on
Important
•
This SP must be done immediately after installation of an HDD unit in a
machine that previously had no HDD.
•
The first time the machine power is turned on with the new HDD installed,
the system automatically takes the address book from the NVRAM and
writes it on the new HDD. However, only the system administrator can use
the new address book on the HDD at this time.
•
If you do SP5846 41 immediately after power on, then all users can use the
address book.
NOTE: It is not necessary to format the new hard disk after installation.
SM
PRINTER AND P/S OPTIONS
11 D318