Bluetooth Unit (B736) - Ricoh B205 Service Manual

1.3.5 BLUETOOTH UNIT (B736)

Accessories
Check the accessories and their quantities against the following list:
Description
1. Bluetooth Unit B736.............................................................1
2. PCI Card..............................................................................1
3. Cap ......................................................................................1

CAUTION
TURN OFF THE MAIN POWER SWITCH AND DISCONNECT THE POWER SUPPLY CORD
NOTE: You can only install one of these network interfaces at the same time: IEEE
802.11b (Wireless LAN), IEEE1284 (Parallel/Centronics), IEEE1394
(FireWire), Bluetooth.
1. Remove the cover [A] of board Slot 1 or 2 ( x1).
2. Attach the interface board [B] to the controller board ( x2 knob screws).
NOTE: Use a screwdriver to tighten the knob-screws. Do not tighten manually,
because this can disconnect the board.
3. Install the Bluetooth card [C] in the slot in the Bluetooth unit.
4. Attach the antenna cap [D].
SM
INSTALLING CONTROLLER OPTIONS
[B]
17
Q'ty
[A]
[C]
[D]
B767I907.WMF
.
B767/B846