Ricoh B205 Service Manual page 267

Rev. 07/15//2009
5816 208 Error Code
Displays a number that describes the error code that was issued when either
SP5816 204 or SP5816 207 was executed.
Cause
Illegal
Modem
Parameter
Operation
Error,
Incorrect
Setting
Error
Caused by
Response
from GW
URL
5816 250 CommLog Print
5821 Remote Service Address Japan Only
5821 1 CSS PI Device
Code
5821 2 RCG IP
Address
⇒
5824 NVRAM Data Upload(See IMPORTANT NOTE in Section 5.9)
Uploads the NVRAM data to an SD card (B140). Push Execute.
Note: When uploading in this SP mode data, the front door must be open.
5825 NVRAM Data Download
Downloads data from an SD card to the NVRAM in the machine. After download is
completed, remove the card and turn the machine power off and on.
SM
Code
-11001 Chat parameter error
-11002 Chat execution error
-11003 Unexpected error
-12002 Inquiry, registration attempted without acquiring device
status.
-12003 Attempted registration without execution of an inquiry
and no previous registration.
-12004 Attempted setting with illegal entries for certification
and ID2.
-12005 @Remote communication is prohibited. The device has
a problem with an internal @Remote function.
-12006 After confirmation is completed, confirmation request
was made again.
-12007 Different request number was used for registration than
the number which was used for confirmation.
-12008 Certification update failed because the device was in
use,
-2385 Attempted dial up overseas without the correct
international prefix for the telephone number.
-2387 Not supported at the Service Center
-2389 Database out of service
-2390 Program out of service
-2391 Two registrations for same device
-2392 Parameter error
-2393 Basil not managed
-2394 Device not managed
-2395 Box ID for external @Remote is illegal
-2396 Device ID for external @Remote is illegal
-2397 Incorrect ID2 format
-2398 Incorrect request number format
Prints the communication log.
Sets the PI device code. After you change this setting, you
must turn the machine off and on.
Sets the IP address of the RCG (Remote Communication
Gate) destination for call processing at the remote service
center.
[00000000h~FFFFFFFFh/1]
5-53
SERVICE PROGRAM MODE
Definition
B205/B209/D007/D008