G3 Interface Unit B768 - Ricoh B205 Service Manual

G3 INTERFACE UNIT B768

1.3 G3 INTERFACE UNIT B768
You can install one of these units (single-port option) or two of them (dual-port
option).

CAUTION
Do the following before you install this option:
1. Print out all data in the printer buffer if there is a printer option in the
machine.
2. Turn off the main switch and disconnect the power cord and the
network.
[B]
[C]
[D]
1. Connect the ribbon cable [A], blue side up, to the CCU DRV board [B].
2. Attach the CCU DRV board to the back of the G3 unit ( x 4).
3. Connect the ribbon cable to the FCU [C], blue side up.
4. Attach the film plate [D] to keep the ribbon cable in the correct position.
5. Remove the connector cover [E] and disconnect the cable. Then remove the
rear cover [F] of the copier ( x 4)
SM
[A]
B766I915.WMF
[F]
[E]
5
B766I914.WMF
B766