Ricoh B205 Service Manual page 695

BIT SWITCHES
System Switch 19
No FUNCTION
0-5 Not used
6 Extended scanner page
memory after memory option
is installed
0: Disabled
1: Enabled
7 Special Original mode
0: Disabled
1: Enabled
System Switch 1A
No. FUNCTION
0-7 LS RX memory capacity
threshold setting
00-FF (0-1020 Kbyte: Hex)
System Switch 1B - Not used (do not change these settings)
System Switch 1C - Not used (do not change these settings)
System Switch 1D
No FUNCTION
0 RTI/CSI/CPS code display
0: Enable
1: Disable
1 Not used
2
Destination telephone number
display limitation
0: OFF, 1: ON
3-7 Not used
SM
COMMENTS
Do not change the settings.
0: After installing the memory expansion option, the
scanner page memory is extended to 4 MB from 2
MB.
1: If this bit is set to 1 after installing the memory
expansion option, the scanner page memory is
extended to 12 MB. But the SAF memory decreases
to 18 MB.
1: If the customer frequently wishes to transmit a form
or letterhead which has a colored or printed
background, change this bit to "1". "Original 1" and
"Original 2" can be selected in addition to the "Text",
"Text/Photo" and "Photo" modes.
COMMENTS
Sets the value to x4KB. When the amount of
available memory drops below this setting, RX
documents are printed to conserve memory.
Initial setting 0x80 (512 KB)
COMMENTS
0: RTI, CSI, CPS codes are displayed on the top line
of the LCD panel during communication.
1: Codes are switched off (no display)
Do not change this setting.
When "1" is selected, the destination telephone
number display is limited and redial is disabled.
Do not change these settings.
45
SP No. 1-101-026
SP No. 1-101-030
B766