Ricoh B205 Service Manual page 234

SERVICE PROGRAM MODE
2901* Separation Voltage Adj
2901 1 Front – Leading Edge
Adjusts the voltage that is applied to the separation plate during printing at the
leading edge of the paper on the front side.
If the copies have pawl marks at the leading edge, increase this voltage.
[–4000 ~ –1000 / –1800 / 1 V/step]
2901 2 Front – Image Area
Adjusts the voltage that is applied to the separation plate during printing on the
image area of the paper on the front side.
If the copies have pawl marks in the image area, increase this voltage.
[–4000 ~ –1000 / –1800 / 1 V/step]
2901 3 Rear – Leading Edge
Adjusts the voltage applied to the separation plate, during printing at the leading
edge of the paper on the rear side.
See SP29011.
[–4000 ~ –1000 / –2100 / 1 V/step]
2901 4 Rear – Image Area
Adjusts the voltage applied to the separation plate, during printing at the image area
of the paper on the rear side.
See SP29012.
[–4000 ~ –1000 / –2100 / 1 V/step]
2902* Test Pattern
2902 3 Test Pattern Printing
2906* Tailing Correction
2906 1 Shift Value
Shifts the image across the page at the interval specified by SP2906 2.
When making many copies of an original that contains vertical lines (such as a
table), separation may not work correctly, then a tailing image will occur (ghosts of
the vertical lines will continue past the bottom of the table). This SP prevents this
problem.
[0.0 ~ 1.0 / 0.0 / 0.1 mm/step]
2906 2 Interval
Changes the interval for the image shift specified by SP2906 1.
[0 ~ 10 / 0 / 1 page/step]
B205/B209/D007/D008
Prints the test patterns. Select the number of the test
pattern that you want to print
2902-2: Not used.
To print the IPU Test Pattern – SP 4417
2902-3: When adjusting the printing registration, select
no.10 (Trimming Area Pattern). [0 ~ 24 / 0 / 1 step]
5-20 SM