Ricoh B205 Service Manual page 722

G3 Switch 0A
No FUNCTION
6 Reconstruction time for the
first line in receive mode
0: 6 s 1: 12 s
7 Not used
G3 Switch 0B Not used (do not change the settings).
G3 Switch 0C Not used (do not change the settings).
G3 Switch 0D Not used (do not change the settings).
G3 Switch 0E
0-7 Set CNG send time interval
Some machines on the receiving side may not be able to automatically switch the 3-
second CNG interval.
High order bit
Low order bit
G3 Switch 0F
No FUNCTION
0 Alarm when an error occurred
in Phase C or later
0: Disabled
1: Enabled
1 Alarm when the handset is off-
hook at the end of
communication
0: Disabled
1: Enabled
2-7 Not used
B766
COMMENTS
When the sending terminal is controlled by a
computer, there may be a delay in receiving page
data after the local machine accepts set-up data and
sends CFR. This is outside the T.30
recommendation. But, if this delay occurs, set this
bit to 1 to give the sending machine more time to
send data.
Refer to error code 0-20.
ITU-T T.30 recommendation: The first line should
come within 5 s of CFR.
Do not change the settings.
3000-2250ms: 3000-50xNms
3000 – 50 x Nms 0F (3000 ms) ≤ N ≤ FF (2250 ms)
00-0E(3000-3700ms: 3000+50xNms
3000 – 50 x Nms 0F (3000 ms) ≤ N ≤ 0F (3700 ms)
COMMENTS
If the customer wants to hear an alarm after each
error communication, change this bit to "1".
If the customer wants to hear an alarm if the
handset is off-hook at the end of fax communication,
change this bit to "1".
Do not change the settings.
72
BIT SWITCHES
SP No. 1-105-011
SP No 1-105-015
SP No. 1-105-016
SM