Table of Contents
Advertisement
®
Intel
IXF1104 4-Port Gigabit Ethernet Media Access Controller
Table 37. Byte Swapper Behavior
UPX_BADD
[1:0]
00
01
10
11
1. In 8-bit mode, data is output in Little Endian format regardless of the
5.10
TAP Interface (JTAG)
The IXF1104 MAC includes an IEEE 1149.1 compliant Test Access Port (TAP) interface used
during boundary scan testing. The interface consists of the following five signals:
•
TDI – Serial Data Input
•
TMS – Test Mode Select
•
TCLK – TAP Clock
•
TRST_L – Active Low asynchronous reset for the TAP
•
TDO – Serial Data Output
TDI and TMS require external pull-up resistors to float the signals High per the IEEE 1149.1
specification. Pull-ups are recommended on TCK and TDO. For normal operation, TRST_L can be
pulled Low, permanently disabling the JTAG interface. If the JTAG interface is used, the TAP
controller must be reset as described in
returned to a logic High.
5.10.1
TAP State Machine
The TAP signals drive a TAP controller, which implements the 16-state state machine specified by
the IEEE 1149.1 specification. Following power-up, the TAP controller must be reset by one of
following two mechanisms:
•
Asynchronous reset
•
Synchronous reset
Asynchronous reset is achieved by pulsing or holding TRST_L Low. Synchronous reset is
achieved by clocking TCLK with five clock pulses while TMS is held or floats High. This ensures
that the boundary scan cells do not block the pin to core connections in the IXF1104 MAC.
123
Little Endian
32-bit
16-bit
UPX_DATA_
UPX_DATA_
[31:0]
[15:0]
[31:0]
[15:0]
–
–
–
[31:16]
–
–
Section 5.10.1, "TAP State Machine" on page 123
1
8-bit
32-bit
UPX_DATA
UPX_DATA
[7:0]
[31:0]
[7:0]
[15:8]
[7:0]
[23:16
[31:24]
[15:8]
–
[23:16]
–
[31:24]
–
IXF1104 MAC
Big Endian
1
16-bit
8-bit
UPX_DATA
UPX_DATA
[15:0]
[7:0]
[7:0]
[7:0]
[15:8]
–
[15:8]
[23:16]
[23:16]
[31:24]
–
[31:24]
Endian setting.
and
Datasheet
Document Number: 278757
Revision Number: 009
Revision Date: 27-Oct-2005
Advertisement
Table of Contents
