Optical Module Interface; Intel® Ixf1104 Mac-Supported Optical Module Interface Signals; Datasheet - Intel IXF1104 Datasheet

®
Intel IXF1104 4-Port Gigabit Ethernet Media Access Controller
5.7

Optical Module Interface

This section describes the connection of the IXF1104 MAC ports to an Optical Module Interface
and details the minimal connections that are supported for correct operation. The registers used for
write control and read status information are documented.
The Optical Module Interface allows the IXF1104 MAC a seamless connection to the Small Form
Factor Optical Modules (SFP) that form the system's physical media connection, eliminating the
need for any FPGAs or CPUs to process data. All required optical module information is available
to the system CPU through the IXF1104 MAC CPU interface, leading to a more integrated,
reliable, and cost-effective system.
The IXF1104 MAC supports all the functions required for the Small Form Factor pluggable Multi-
Source Agreement (MSA).
There are specific mechanical and electrical requirements for the size, form factor, and connections
supported on all Optical Module Interfaces. There are also specific requirements for each Optical
Module Interface that supports a particular media requirement or interface configuration. These
requirements are detailed in the relevant specifications or manufacturers' datasheets.IXF1104
MAC
5.7.1 Intel® IXF1104 MAC-Supported Optical Module Interface Signals
To describe the Optical Module Interface operation, three supported signal subgroups are required,
allowing a more explicit definition of each function and implementation. The three subgroups are
as follows:
•
High-Speed Serial Interface
•
Low-Speed Status Signaling Interface
•
I²C Module Configuration Interface
Table 30 provides descriptions for IXF1104 MAC-to-SFP optical module connection signals.
®
Table 30. Intel IXF1104 MAC-to-SFP Optical Module Interface Connections (Sheet 1 of 2)
IXF1104 MAC
Signal Names
TX_P_0:3
TX_N_0:3
RX_P_0:3
RX_N_0:3
2
I C_CLK
2
I C_DATA_0:3
MOD_DEF_0:3
107
SFP Signal
Description
Names
TD+ Transmit Data, Differential LVDS
TD- Transmit Data, Differential LVDS
RD+ Receive Data, Differential LVDS
RD- Receive Data, Differential LVDS
2
I C_CLK output from the
MOD-DEF1
IXF1104 MAC (SCL)
2
MOD-DEF2 I C_DATA I/O (SDA)
MOD_DEF_0 is TTL Low level
MOD-DEF0
during normal operation.
Notes
Output from the IXF1104 MAC
Output from the IXF1104 MAC
Input to the IXF1104 MAC
Input to the IXF1104 MAC
Output from the IXF1104 MAC
Input/Output
Input to the IXF1104 MAC

Datasheet

Document Number: 278757
Revision Number: 009
Revision Date: 27-Oct-2005