Transmit Pause Control Interface Signal Descriptions; Optical Module Interface Signal Descriptions - Intel IXF1104 Datasheet

4-port gigabit ethernet media access controller
Table of Contents

Advertisement

®
Intel
IXF1104 4-Port Gigabit Ethernet Media Access Controller
Table 8.

Transmit Pause Control Interface Signal Descriptions

Signal Name
TXPAUSEADD2
TXPAUSEADD1
TXPAUSEADD0
TXPAUSEFR
Table 9.
Optical Module Interface Signal Descriptions (Sheet 1 of 2)
Signal Name
TX_DISABLE_0
TX_DISABLE_1
TX_DISABLE_2
TX_DISABLE_3
MOD_DEF_0
MOD_DEF_1
MOD_DEF_2
MOD_DEF_3
RX_LOS_0
RX_LOS_1
RX_LOS_2
RX_LOS_3
TX_FAULT_0
TX_FAULT_1
TX_FAULT_2
TX_FAULT_3
RX_LOS_INT
53
Ball
Type
Standard
Designator
P21
2.5 V
P20
Input
CMOS
N20
2.5 V
T20
Input
CMOS
Ball
Type
Standard
Designator
AB3
Open
AA7
2.5 V
Drain
AD16
CMOS
Output*
AA14
Y6
AD10
2.5 V
Input
W22
CMOS
T16
AB5
AA11
2.5 V
Input
V19
CMOS
T18
Y5
AC11
2.5 V
Input
V20
CMOS
T17
Open
2.5 V
P19
Drain
CMOS
Output*
Description
TXPAUSEADD[2:0] is the port selection address
for pause frame insertion.
TX Pause Interface Strobe.
Description
Transmit Disable:
TX_DISABLE_0:3 outputs disable the Optical
Module Interface transmitter. An external pull-up
resistor usually resident in an optical module is
required for proper operation.
NOTE: These signals are multiplexed with the
TXD[4]_n bits of the GMII Interface
NOTE: *Dual-mode I/O
Normal operation: Open drain output
Boundary Scan Mode: Standard CMOS
output
MOD_DEF_0:3 inputs determine when an
Optical Module Interface is present.
NOTE: These signals are multiplexed with the
RXD[4]_n bits of the GMII interface.
RX_LOS_0:3 inputs determine when the Optical
Module Interface receiver loses synchronization.
NOTE: These signals are multiplexed with the
RXD[6]_n bits of the GMII interface.
TX_FAULT_0:3 inputs determine an Optical
Module Interface transmitter fault.
NOTE: These signals are multiplexed with the
RXD[5]_n bits of the GMII Interface.
Receiver Loss of Signal Interrupt.
RX_LOS_INT is an open drain interrupt output to
signal an RX_LOS condition.
NOTE: An external pull-up resistor is required
for proper operation.
NOTE: *Dual-mode I/O
Normal operation: Open drain output
Boundary Scan Mode: Standard CMOS
output
Document Number: 278757
Revision Number: 009
Revision Date: 27-Oct-2005
Datasheet

Advertisement

Table of Contents
loading

Table of Contents