I²C Protocol Specifics; Datasheet - Intel IXF1104 Datasheet

b. Set the port to be accessed by setting Register bits 17:16 to 0x3.
c. Select a Write access by setting Register bit 15 to 0x0.
d. Set the Device ID Register bits 14:11 to Ah (Atmel compatible).
e. Set the 11-bit register address (Register bits 10:0) to 0FFh.
f. Enable the I
g. Initiate the I
All other bits in this register should be set to 0x0.
This data is written into the
interface.
2. When this register is written and the I
examines the Port Address Select and enables the I
3. The state machines uses the data in the Device ID and Register Address fields to build the data
frame to be sent to the optical module
2
4. The I
actual data between the IXF1104 MAC and the selected optical module (refer to the details in
Section 5.7.3.4, "I²C Protocol Specifics" on page
2
5. The I
bits [23:16] of the
Register bit 22 of the
Access is complete.
6. The data is written through the CPU interface. The CPU must poll the Write_Complete bit
until it is set to 0x1. It is safe to request a new access only when this bit is set.
Note: Only one optical module I
Write is lost if a second Write is carried out to the
result is returned for the previous Write. Make sure Write complete = 0x1 before starting the next
Write sequence to ensure that no data is lost.
5.7.3.4 I²C Protocol Specifics
Section 5.7.3.4
internal state machine. Specific protocol states are defined below, with an additional description of
the hardware signals used on the interface.
The Serial Clock Line (I
synchronous with this clock and is driven off the rising edge by the IXF1104 MAC and off the
falling edge by the optical module. The IXF1104 MAC has only one I
of the optical modules. I
The Serial Data (I
These signals are open drain.

Datasheet

Document Number: 278757
Revision Number: 009
Revision Date: 27-Oct-2005
®
Intel IXF1104 4-Port Gigabit Ethernet Media Access Controller
2
C controller by setting Register bit 2 to 0x1.
2
C transfer by setting Register bit 24 to 0x1.
2
"I C Control Ports 0 - 3 ($0x79B)"
C_DATA_WRITE_FSM internal state machine takes over the task of transferring the
C_DATA_WRITE_FSM internal state machine uses the data from the Write_Data field
2
"I C Data Ports 0 - 3 ($0x79F)" on page 223
2
"I C Control Ports 0 - 3 ($0x79B)"
2
C access sequence can be run at any given time. The data for the first
describes the IXF1104 MAC I²C Protocol behavior, which is controlled by an
2
C_CLK) is an output from the IXF1104 MAC. The serial data is
2
C_CLK runs continuously when enabled (I²C Enable = 01h0).
2
C_DATA_3:0) signals (one per port) are bi-directional for serial data transfer.
in a single cycle via the CPU
2
C Start bit is at a Logic 1, the I
2
C_DATA_0:3 output for the selected port.
112).
and sets the Write_Complete
to 0x1 to signify that the Write
2
"I C Control Ports 0 - 3 ($0x79B)"
2
C access state machine
before a
2
C_CLK line that drives all
112