Cr Hp Sensor - Epson Stylus Pro 7400 Service Manual

EPSON Stylus Pro 7400/7800/9400/9800

4.2.5.3 CR HP Sensor

1. Remove the MAIN TUBE HOLDER.
When performing the next step, be careful not to pull out the MAIN
C A U T I O N
TUBE HOLDER forcibly as TUBE, SUPPLY, INKs are routed
inside the holder.
TUBE, SUPPLY, INK
Figure 4-60. Handling the MAIN TUBE HOLDER
2. Pull out the MAIN TUBE HOLDER frontward, and release the three hooked tabs
that secure the CR HP Sensor and remove the sensor.
3. Disconnect the connector from the CR HP Sensor.
Disassembly & Assembly
See Section 4.2.5.1 on page 240.
Disassembly Procedure
CR HP Sensor
Hooked Tabs
Figure 4-61. Removing the CR HP Sensor
Revision B
Connector
244