Mechanism Specifications - Epson Stylus Pro 7400 Service Manual

EPSON Stylus Pro 7400/7800/9400/9800

1.2.5 Mechanism Specifications

1.2.5.1 Printable Area
Table 1-11. Printable Area
Roll paper
Item
/Cut Sheet
1
Roll paper *
PW
(Paper width)
Cut Sheet
Roll paper
PL
(Paper length)
Cut Sheet
Roll paper
TM
(Top margin)
Cut Sheet
Roll paper
BM
(Bottom margin)
Cut Sheet
Roll paper
LM
(Left margin)
Cut Sheet
Roll paper
RM
(Right margin)
Cut Sheet
Note "*1": The printer automatically detects paper width when the paper is set if the automatic
detection function is set to ON.
"*2": Some types of roll paper have exceptional TM of over 15mm.
Note • Images that exceed the detected paper width, or exceed the specified printing range in
the size settings, are not printed.
(If the paper width detection settings are OFF, the printer may print to the platen.)
*At this time, a rainbow phenomenon is not generated.
• The margin settings can be changed using the panel as shown below for roll paper.
TM, BM 15mm LM, RM 3mm/ TM, BM, LM, RM 3mm/ TM, BM, LM, RM 15mm/
TM 35mm BM 15mm LM, RM 3mm
*In the special conditions below, it is possible to set the left and right margins (LM,
RM) to zero.
Product Description
Model Dimension
Stylus Pro 7400/7800 203mm~610mm
Stylus Pro 9400/9800 203mm~1,118mm
Stylus Pro 7400/7800 203mm~610mm
Stylus Pro 9400/9800 203mm~1,118mm
All models Maximum 202m
All models 279mm~1,580mm
All models 3mm / 15mm /
All models 3mm
All models 3mm / 15mm
All models 14mm
All models 0mm / 3mm / 15mm
All models 0mm / 3mm
All models 0mm / 3mm / 15mm
All models 0mm / 3mm
3: When printing off both left and right edges of the media, the bleed on both sides is set to
3 mm as the automatic skew detection function can sense 3 mm or more horizontal shift
of the media during printing. If the printer detects that the bleeding width (from left or
right edge of media to the platen edge) is less than 3 mm, it reduces the bleed print
amount to avoid printing on the platen.
2
35mm*
Basic Specifications
Printable Area
Figure 1-1. Printable Area
Revision B
23