EPSON Stylus Pro 7400/7800/9400/9800
When performing the next step, be careful not to lose the Bearing
C A U T I O N
Retainer and the Driven Pulley Shaft as they may come off the CR
DRIVE PULLEY ASSY. If they come off, reattach them with
reference to the figure below.
Driven Pulley Shaft
Figure 4-54. Reassembling the CR DRIVE PULLEY ASSY.
5.
Remove the CR DRIVE PULLEY ASSY. and the CR BELT from the two notches
of the Driven Pulley Tension Plate, and remove the CR BELT from the CR
DRIVE PULLEY ASSY.
See Figure 4-55.
6.
Remove the two screws that secure the MAIN TUBE HOLDER.
Two C.P.S.(S-P2) M3 x 8 screws
Set the two positioning holes of the MAIN TUBE HOLDER onto
the two guide pins.
See Figure 4-56.
Disassembly & Assembly
Bearing Retainer
TUBE, SUPPLY, INK
See Figure 4-56.
Disassembly Procedure
CR DRIVE PULLEY ASSY.
Notches
Figure 4-55. Removing the CR BELT (2)
MAIN TUBE HOLDER
Guide Pins
C.P.S.(S-P2) 3x8
Figure 4-56. Screws for the MAIN TUBE HOLDER
Revision B
241