Epson Stylus Pro 7400 Service Manual page 284
Large format color inkjet printer
Hide thumbs
Also See for Stylus Pro 7400:
- Unpacking and setup manual (27 pages) ,
- Notice sheet (4 pages) ,
- User manual (393 pages)
Table of Contents
Advertisement
EPSON Stylus Pro 7400/7800/9400/9800
4.2.7.4 PUMP CAP ASSY.
When removing the PUMP CAP ASSY., ink may leak out of the
C A U T I O N
Waste Ink Tubes and the Ink Exhaust. Have a waste cloth
beforehand to clean up.
1.
Remove the R SIDE COVER ASSY.
2.
Release the harnesses of the Pump Motor from the retaining clip.
3.
Disconnect the Pump Motor connector from the relay connector.
4.
Pull the Waste Ink Tubes out of the Ink Exhaust.
When reinstalling the Waste Ink Tube, make sure to insert it
C A U T I O N
correctly into the waste ink outlet and route the tubes as shown in
the figure right, or ink may leak.
5.
Release the two locks of each of the two retaining clips with locks that secure the
Pump Motor harnesses and the Waste Ink Tubes and release them from the clips.
Disassembly & Assembly
See Section 4.2.3.4 on page 223.
Disassembly Procedure
Right Rear of the Printer
Retaining Clips
With Locks
Locks
Waste Ink Tubes
Ink Exhaust
Figure 4-135. Releasing the Pump Motor Harnesses and Waste Ink Tubes
Revision B
Relay Connector
Pump Motor
Harnesses
Retaining Clip
284
Advertisement
Chapters
Table of Contents
Troubleshooting
