Epson Stylus Pro 7400 Service Manual page 282

EPSON Stylus Pro 7400/7800/9400/9800
When performing the next step, be careful not to pull the HOLDER
C A U T I O N
ASSY., IC, LEFT too much as it is still connected to the printer
with the TUBE, SUPPLY INK.
11. Release the hooked tab that secures the HOLDER ASSY., IC, LEFT, and remove
it.
When reinstalling the HOLDER ASSY., IC LEFT, be careful not to
C A U T I O N
trap the Front Sensor harness and the TUBE, INK, WASTE; L
between the two screwed tabs and the frame.
TUBE, INK, WASTE; L
Figure 4-130. Screwed Tabs located at Upper Side of the HOLDER
Disassembly & Assembly
Screwed tabs
Front Sensor
Harness
ASSY., IC, LEFT
Disassembly Procedure
Make sure to insert the two tabs of the HOLDER ASSY., IC, LEFT
into the two slots.
Tabs
Figure 4-131. Reinstalling the HOLDER ASSY., IC, LEFT
Hooked tab
11-1
11-2
Figure 4-132. Removing the HOLDER ASSY., IC, LEFT (1)
Revision B
282