Epson Stylus Pro 7400 Service Manual page 245

EPSON Stylus Pro 7400/7800/9400/9800
4.2.5.4 PG HP Sensor
1. Remove the MAIN TUBE HOLDER.
When performing the next step, be careful not to pull out the MAIN
C A U T I O N
TUBE HOLDER forcibly as TUBE, SUPPLY, INKs are routed
inside the holder.
TUBE, SUPPLY, INK
Figure 4-62. Handling the MAIN TUBE HOLDER
2. Pull out the MAIN TUBE HOLDER frontward, and release the three hooked tabs
that secure the PG HP Sensor and remove the sensor.
3. Disconnect the connector from the PG HP Sensor.
Disassembly & Assembly
See Section 4.2.5.1 on page 240.
Disassembly Procedure
Connector
Hooked Tabs
Figure 4-63. Removing the PG HP Sensor
Revision B
PG HP Sensor
245