Epson Stylus Pro 7400 Service Manual page 287

EPSON Stylus Pro 7400/7800/9400/9800
4.2.7.5 CLEANER, HEAD, A, ASP
1. Remove the PUMP CAP ASSY.
Never touch the CLEANER, HEAD, A, ASP with bare hands as the
C A U T I O N
oil of your hand remained on the cleaner surface may repel ink and
cause partial dot omission. Use a pair of tweezers cleaned by a
cleaner or etc. to handle the CLEANER, HEAD, A, ASP.
2. Release the CLEANER, HEAD, A, ASP from the two hooked tabs, and remove it
from the PUMP CAP ASSY.
Make sure to install the CLEANER, HEAD, A, ASP in the correct
orientation as shown in the figure below.
Opposite to the home
direction
Figure 4-140. Orientation of the CLEANER, HEAD, A, ASP
Whenever the CLEANER, HEAD, A, ASP is replaced, the
A D J U S T M E N T
R E Q U I R E D
corresponding adjustment must be carried out.
page 292.
Disassembly & Assembly
See Section 4.2.7.4 on page 284.
To the Carriage home
direction
See Chapter 5 on
Figure 4-141. Removing the CLEANER, HEAD, A, ASP
Disassembly Procedure
Revision B
CLEANER, HEAD, A, ASP
Hooked tabs
287