EPSON Stylus Pro 7400/7800/9400/9800
4.2.6.6 P Rear Sensor
1.
Remove the P Thick Sensor Mounting Plate.
2.
Disconnect the FFC from the connector.
3.
Release the two tabs that secure the P Rear Sensor and remove it.
Whenever the P Rear Sensor is reinstalled or replaced, the
A D J U S T M E N T
R E Q U I R E D
corresponding adjustment must be carried out.
page 292.
Disassembly & Assembly
See Section 4.2.6.5 on page 261.
See Chapter 5 on
Disassembly Procedure
FFC
Tabs
Connector
P Rear Sensor
Figure 4-95. Removing the P Rear Sensor
Revision B
262