Epson Stylus Pro 7400 Service Manual page 231

EPSON Stylus Pro 7400/7800/9400/9800
4.2.3.10 Front Sensor
1. Open the FRONT COVER ASSY.
2. Remove the screw that secures the FRONT SENSOR COVER.
One C.C.S. M3 x 8 screw
3. Release the tab that secures the FRONT SENSOR COVER and turn it in the
direction shown in the figure. See Figure 4-36.
Set the guide pin of the FRONT SENSOR COVER into the
positioning hole on the frame.
Insert the tab of the FRONT SENSOR COVER into the slot of
the frame.
Figure 4-35. Reinstalling the FRONT SENSOR COVER
4. Release the two hooked tabs that secure the FRONT SENSOR and remove it.
Figure 4-37.
5. Remove the connector from the FRONT SENSOR.
Disassembly & Assembly
See Figure 4-36.
Guide Pin
Tab
See
See Figure 4-37.
Disassembly Procedure
Left Side of the Printer
FRONT SENSOR COVER
Tab
Figure 4-36. Removing the FRONT SENSOR COVER
Hooked tabs
Figure 4-37. Removing the FRONT SENSOR
Revision B
C.C.S 3x8
FRONT SENSOR
Connector
231