Epson Stylus Pro 7400 Service Manual page 247

EPSON Stylus Pro 7400/7800/9400/9800
4. Disconnect the FFC from the CR Encoder Sensor connector.
5. Remove the screw that secures the CR Encoder Sensor and remove it.
One C.B.P. M3 x 6 screw
Set the two positioning holes of the CR Encoder Sensor onto the two
guide pins.
Whenever the CR Encoder Sensor is reinstalled or replaced, the
A D J U S T M E N T
R E Q U I R E D
corresponding adjustment must be carried out.
page 292.
Disassembly & Assembly
See Chapter 5 on
Disassembly Procedure
CR Encoder Sensor
Connector
Guide Pins C.B.P. 3x6
Figure 4-66. Removing the CR Encoder Sensor
Revision B
FFC
247