Epson Stylus Pro 7400 Service Manual page 345

EPSON Stylus Pro 7400/7800/9400/9800
13. Make sure there is no missing dots in the nozzle check pattern at the bottom of the
calibration chart.
If there are missing dots, click [Print Calibration Chart Again]. The calibration chart
will be printed again after performing cleaning.
If there are no missing dots, let the chart stand for five minutes until it dries out paying
attention not to touch the chart.
14. When the calibration chart dries out (after five minutes), click [Next].
15. Connect a calibrator to the computer, and click [Measure].
16. Place the calibrator on the calibration base plate, and click [Calibrate]
17. Keep the calibrator remain set on the base plate, hold down the button on the side of
the calibrator until it beeps.
Once the calibration completed normally, following screen appears.
White Plate
Figure 5-67. i1Calibrator
Adjustment
C A U T I O N
i1 Calibrator
Button
Calibration Plate
Basic Adjustment
Do not contaminate the white plate of the calibration base plate. If
tainted, use alcohol to clean the plate.
Figure 5-68. Entire Process Screen
Revision B
345