EPSON Stylus Pro 7400/7800/9400/9800
6.
Remove the screw that secures each of the two SEAL, HOLDs, and remove them.
See Figure 4-77.
Two C.C.S. M3 x 8 screws
The SEAL, HOLD is not included in the Stylus Pro 7400/7800.
C H E C K
P O I N T
7.
Disconnect the three connectors of the VACUUM FAN ASSY. from the relay
connectors.
See Figure 4-78.
8.
Release the two relay harnesses from the five retaining clips (two clips on the
center, and three clips on the right side) of the VACUUM FAN ASSY.
4-78.
Route the two relay harnesses as shown in the figure below.
Center
Wind the relay harness to be connected to the left
VACUUM FAN ASSY. around the hooked tab.
Right Side
Wind the relay harness to be
connected to the left VACUUM
FAN ASSY. around the hooked tab.
Figure 4-76. Releasing the Relay Harnesses
Disassembly & Assembly
See Figure
Wind the relay harness to be
connected to the center VACUUM
FAN ASSY. around the hooked tab.
Disassembly Procedure
SEAL, HOLD
C.C.S. 3x8
Figure 4-77. Removing the SEAL, HOLD
Connector
Relay harness
Center
Hooked tabs
Figure 4-78. Releasing the Relay Harnesses
Revision B
Relay harness
Right Side
Hooked tabs
253