Epson Stylus Pro 7400 Service Manual page 25

EPSON Stylus Pro 7400/7800/9400/9800
BORDERLESS PRINTING SETTING PROCEDURES
Table 1-14. Borderless Printing Setting
Borderless
Right/left borderless
print mode
Printer
operation
Driver Borderless print • Borderless print
setting
• Single Cut
Remarks Defined as default • As the top edge of the
• As this mode cuts the
Product Description
4 sides borderless 4 sides borderless
Single Cut Double Cut
• Borderless print
• Double Cut
• As the top edge of the
first page is cut by first page is cut by
interrupting the printing interrupting the printing
operation, off-registration operation, off-registration
may occur causing may occur causing
irregular color on the irregular color on the
printed image depending printed image depending
on the print job. on the print job.
• The cutting position is set
paper on the boundary of to a line 1 mm inside from
pages, slight amount of the actual top and bottom
image of the previous or edges allowing for cutter
the next page may be left position deviation. So the
on the top or bottom edge length of the printout
of the printout due to becomes about 2mm
cutter position deviation. smaller than the specified
size.
BORDERLESS PRINTING GUARANTEE CONDITIONS
Borderless printing guarantee conditions
Environmental:
Temperature: 59 to 77ºF (15 to 25 ºC), Humidity: 40 to 60 % RH
Media type *
4
Media size *
• Photo type media:
POP • poster type media: A1, B1, B2
•
NOTE "*1": For details on borderless printing guaranteed media, refer to
Allowable EPSON and Other Media"
"*2": There are no borderless printing guarantees for cut sheet paper.
"*3": Borderless printing is not guaranteed if a number of outer layers of the
roll surface have stretched due to moisture absorption.
"*4": Borderless ptinting on media and sizes other than those listed above are
guaranteed the same way as the Stylus Pro 7600/9600 do. However, if
media that has been stretched by humidity and other environmental
conditions is used, it is possible that borders on the right and left hand
sides may occur.
Bleeding print width for printing off both left and right edges
The bleeding print width for the left and right edges can be selected among the
following settings using the printer driver.
Left (opposite home side) = 1.5mm/ Right (home side) = 1.5mm
Left (opposite home side) = 3.0mm/ Right (home side) = 3.0mm (Default)
Left (opposite home side) = 5.0mm/ Right (home side) = 3.0mm
NOTE "*1": If humid environmental conditions have caused the media to stretch,
"Left (opposite home side) = 5.0mm/ Right (home side) = 3.0mm"
selection is recommended to prevent left and right edge margins
occurring.
"*2": The "Left (opposite home side) = 5.0mm/ Right (home side) = 3.0mm"
setting shifts the center position of the image 1 mm away from that of
the print data.
Basic Specifications
4
: Photo type media (roll paper),
POP • poster type media (roll paper)
10", 300mm, 13", 16", 17", 24", 36", 44"
(p.18).
Revision B
1, 2, 3
* * *
"1.2.4.4
* 1, * 2
25