Epson Stylus Pro 7400 Service Manual page 352

EPSON Stylus Pro 7400/7800/9400/9800
33. Click [OK] and follow the instructions (following procedure) displayed on the screen
to perform color measuring.
1. Set the calibrator with its measuring part matched with measuring start
position (gray part) as shown in
2. Press the button on the side of the calibrator.
3. When it beeps, keep holding down the button and scan the patch along the
scanning ruler to measuring end position (gray part).
4. Once the measuring is complete, release the button.
5. Repeat Step 1 through 4 twice for the same patch line.
6. Repeat Step 1 through 5 to measure the bottommost line to the top line. (The
line which needs to be measured is displayed on the screen.)
34. Once all the lines (5 lines) are measured, click [OK].
35. Measure Sheet 2 by following Step 31 through 34.
Figure 5-79. Color Measuring Order
Adjustment
Figure 5-72.
Start position in the color measuring
Figure 5-80. Setting the Calibrator/Color Measuring Position
Figure 5-81. Color Measuring Screen
Basic Adjustment
Revision B
End position in the color measuring
352