Chapter 103 Switch Port Commands; Config Ports - D-Link xStack Reference Manual

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
Chapter 103 Switch Port
config ports [<portlist> | all] {medium_type [fiber | copper]} {speed [auto {capability_advertised
{10_half | 10_full | 100_half | 100_full | 1000_full}} | 10_half | 10_full | 100_half | 100_full |
1000_full {[master | slave]}] | auto_negotiation [restart_an | remote_fault_advertised [disable |
offline | link_fault | auto_negotiation_error]] | flow_control [enable | disable] | learning [enable |
disable] | state [enable | disable] | mdix [auto | normal | cross] | [description <desc 1-32> |
clear_description]}(1)
show ports {<portlist>} {[description | err_disabled | auto_negotiation | details | media_type]}

103-1 config ports

Description
This command is used to change switch port settings.
Format
config ports [<portlist> | all] {medium_type [fiber | copper]} {speed [auto
{capability_advertised {10_half | 10_full | 100_half | 100_full | 1000_full}} | 10_half | 10_full |
100_half | 100_full | 1000_full {[master | slave]}] | auto_negotiation [restart_an |
remote_fault_advertised [disable | offline | link_fault | auto_negotiation_error]] |
flow_control [enable | disable] | learning [enable | disable] | state [enable | disable] | mdix
[auto | normal | cross] | [description <desc 1-32> | clear_description]}(1)
Parameters
<portlist> - Enter a range of ports to be configured.
all – Specify to set all ports in the system.
medium_type - (Optional) Specify the medium type when configuring ports that are combo ports.
fiber - Specifies the fiber port.
copper - Specifies the copper port.
speed - Set port speed for the specified ports.
auto - Set port speed to auto negotiation.
capability_advertised - Specifies that the capability will be advertised.
10_half - Set port speed to 10_half.
10_full - Set port speed to 10_full.
100_half - Set port speed to 100_half.
100_full - Set port speed to 100_full.
1000_full - Set port speed to 1000_full. When setting copper port speed to 1000_full, users
should specify master and slave mode in pair for 1000-BASE TX, and leave the
1000_full without any master or slave setting for fiber.
master - (Optional) Set to master.
slave - (Optional) Set to slave.
auto_negotiation - Specifies that the auto-negotiation option will be configured.
restart_an - Specifies to restart the auto-negotiation process.
remote_fault_advertised - Specifies that the remote fault advertisement option will be
configured.
disable - Specifies to disable remote fault advertisement.
Commands
1122