Config Gvrp - D-Link xStack Reference Manual

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
Restrictions
None.
Example
To display 802.1q port settings for ports 1 to 3:
DGS-3620-28SC:admin#show port_vlan 1-3
Command: show port_vlan 1-3
Port PVID GVRP
------- ---- --------
1 1 Disabled
2 1 Disabled
3 1 Disabled
Total Entries : 3
DGS-3620-28SC:admin#

113-9 config gvrp

Description
This command is used to set the GVRP timer's value.
Format
config gvrp [timer [join | leave | leaveall] <value 100-100000> | nni_bpdu_addr [dot1d |
dot1ad]]
Parameters
timer – Specify GVRP timer.
join - Specifies the Join time will be set. The default value is 200 milliseconds.
leave - Specifies the Leave time will be set. The default value is 600 milliseconds.
leaveall - Specifies the LeaveAll time. The default value is 10000 milliseconds.
<value 100-100000> - Enter the time value. The value range is 100 to 100000 milliseconds. In
addition, the Leave time should greater than 2 Join times and the LeaveAll time should greater
than Leave time.
nni_bpdu_addr - Determine the BPDU protocol address for GVRP in service provide site. It can
use 802.1d GVRP address, or 802.1ad service provider GVRP address.
dot1d - Specifies a 802.1d GVRP address.
dot1ad - Specifies a 802.1ad service provider GVRP address.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To set the Join time to 200 milliseconds:
Ingress Checking Acceptable Frame Type
---------------- ----------------------------
Enabled All Frames
Enabled All Frames
Enabled All Frames
1201