Table of Contents
Advertisement
Chapter 5
CLI – Layer 2
The syntax for this command is:
set port negotiation <mod_num>/<port_num> {enable|disable}
Output Example:
To disable autonegotiation on port 1, module 4:
P330-N# set port negotiation 4/1 disable
Link negotiation protocol disabled on port 4/1.
set port enable
Use the set port enable command to enable a port or a range of ports.
The syntax for this command is:
set port enable [mod_num/port_num]
mod _num
port_num
Output Example:
To enable port 3 on module 2:
P330-N# set port enable 2/3
Port 2/3 enabled.
set port disable
Use the set port disable command to disable a port.
The syntax for this command is:
set port disable <mod_num>/<port_num>
Output Example:
P330-N# set port disable 5/10
Port 5/10 disabled.
96
The switch number
The port number
Avaya P333T-PWR User's Guide
Advertisement
Table of Contents
