Chapter 5
Cajun Campus CLI – Layer 2
Set port enable Command
Use the set port enable command to enable a port or a range of ports.
The syntax for this command is:
set port enable [mod_num/port_num]
mod _num
port_num
Example:
To enable port 3 on module 2:
P330-N# set port enable 2/3
Port 2/3 enabled.
Set port disable Command
Use the set port disable command to disable a port.
The syntax for this command is:
set port disable [module/port]
module/port
Example:
P330-N(super)# set port disable 1/4
Port 1/4 disabled.
Set port speed Command
Use the set port speed command to configure the speed of a 10/100Base-T
port. You can configure the speed to either 10 Mbps or 100 Mbps. If autonegotiation
mode is enabled for such ports, the port's speed is determined by autonegotiation,
an error message is thus generated if you attempt to set the speed in this case.
The syntax for this command is:
set port speed <mod_num>/<port_num> {10MB|100MB}
104
The module number
The port number
The module/port number
Avaya P333R-LB User's Guide