Set Port Speed Command; Set Port Duplex Command - Avaya P130 User Manual

Set port speed Command

Use the set port speed command to configure the speed of a port or range of
ports.
In autonegotiation mode, the port's speed is determined by autonegotiation. You
cannot set the speed type to 10 or 100 when autonegotiation is enabled.
The syntax for this command is:
set port speed <mod_num/port_num><speed>
mod_num
port_num
<speed>
Example:
To configure port 2 on module 1 port speed to 10 Mbps:
P130-1# set port speed 1/2 10MB
Port 1/2 speed set to 10 Mbps.

Set port duplex Command

Use the set port duplex command to configure the duplex type of an Ethernet
or Fast Ethernet port or range of ports.
You can configure Ethernet and Fast Ethernet interfaces to either full duplex or half
duplex. The duplex status of a port in autonegotiation mode is determined by
autonegotiation. An error message is generated if you attempt to set the
transmission type of autonegotiation Fast Ethernet ports to half- or full-duplex
mode.
The syntax for this command is:
set port duplex <mod_num/port_num> {full | half}
mod_num
port_num
full
half
Avaya P130 User's Guide
Module number
Number of the port on the module
Set port speed to 10, or 100 Mbps
Module number
Number of the port on the module
Keyword to specify full-duplex transmission
Keyword to specify half-duplex transmission
Chapter 6 Avaya P130 CLI
73