Set Port Speed; Set Port Duplex - Avaya P334T-ML User Manual

Chapter 6 CLI – Layer 2

set port speed

Use the set port speed command to configure the speed of a 10/100Base-T
port. If autonegotiation mode is enabled for such ports, the port's speed is
determined by autonegotiation, and an error message is thus generated if you
attempt to perform the set port speed command on an autonegotiation
enabled port.
Note: This command does not apply to P332G-ML, P332GT-ML and ports 51,52 of
the P334T-ML.. An error message is generated if you attempt to perform the set
port speed command for these ports.
The syntax for this command is:
set port speed <mod_num>/<port_num> {value}
Output Example:
To configure port 2 on module 2 port speed to 10 Mbps:
P330-N# set port speed 2/2 10MB
Port 2/2 speed set to 10 Mbps.

set port duplex

Use the set port duplex command to configure the duplex mode of a
10/100Base-T port. You can configure the duplex mode to either Half or Full
duplex. If autonegotiation mode is enabled for a 10/100 port, the port's duplex
mode is determined by autonegotiation, and an error message is thus generated if
you attempt to perform the set port duplex command on an autonegotiation
enabled port.
Note: P332G-ML, P332GT-ML and ports 51,52 of the P334T-ML work in Full duplex
mode only. An error message is generated if you attempt to change these ports to
half-duplex.
The syntax for this command is:
set port duplex <mod_num>/<port_num> {full|half}
Example:
To set port 1 on module 2 to full duplex:
P330-N# set port duplex 2/1 full
112
Avaya P334T-ML User's Guide