Set Port Duplex Command; Set Port Name Command - Avaya P333R-LB User Manual

Example:
To configure port 2 on module 2 port speed to 10 Mbps:
P330-N# set port speed 2/2 10MB
Port 2/2 speed set to 10 Mbps.

Set port duplex Command

Use the set port duplex command to configure the duplex mode of a 10/
100Base-T port. You can configure the duplex mode to either Half or Full duplex. If
autonegotiation mode is enabled for such ports, the port's duplex mode is
determined by autonegotiation, an error message is thus generated if you attempt to
set the duplex mode in this case.
The syntax for this command is:
set port duplex <mod_num>/<port_num> {full|half}
Example:
To set port 1 on module 2 to full duplex:
P330-N# set port duplex 2/1 full
Port 2/1 set to full-duplex.

Set port name Command

Use the set port name to configure a name for a port. If you do not specify a
name, the port name remains empty.
The syntax for this command is:
set port name <mod_num>/<port_num> [<name>]
name
Example:
P330-N# set port name 1/21 arthur
Port 1/21 name set.
Note: If you wish to define a name which includes spaces, you must enclose the
entire name in quotation marks, e.g. "new york".
Avaya P333R-LB User's Guide
Name assigned to the port.
Chapter 5 Cajun Campus CLI – Layer 2
105