Interface Mode; Ip Rip Rip-Version Command; Default-Metric Command - Avaya P334T-ML User Manual

Interface Mode

ip rip rip-version Command

Use the ip rip rip-version command to specify the RIP version running on
the interface basis.
The syntax for this command is:
ip rip rip-version [1][2]
The possible versions of the RIP packets received and sent on an interface are:
[1]
[2]
Example:
To specify that RIP version 2 should be running on the basis of the interface
"marketing":
Router-N(config-if:marketing)# ip rip rip version 2

default-metric Command

Use the default-metric command to set the interface RIP route metric. The no
form of this command restores the default. The default metric is 1.
The syntax for this command is:
[no] default-metric <number>
number
Example:
To set the default RIP metric value. The range is 0 to 15:
Router(config-if:marketing)# default-metric 10
P334T-ML User's Guide
RIP Version 1 packets
RIP Version 2 packets.
The interface RIP route metric value. The range is 0 to 15.
Chapter 7 CLI – Layer 3
179