Chapter 7
CLI – Layer 3
ip netmask-format Command
Use the ip netmask-format command to specify the format of netmasks in the
show command output. The no form of this command restores to the default,
which is a dotted decimal format.
The syntax for this command is:
[no] ip netmask-format <mask-format>
The possible mask formats are:
bitcount
decimal
hexadecimal
Example:
To display netmasks in bitcount format:
Router-N(configure)# ip netmask-format bitcount
172
Addresses are followed by a slash and the total number of bits
in the netmask. For example 17
The network masks are in dotted decimal notation. For
example, 255.255.255.0.
The network masks are in hexadecimal format as indicated by
the leading 0X. For example, 0XFFFFFF00.
P334T-ML User's Guide