Set Port Name Command; Set Port Trap Command - Avaya P130 User Manual

Chapter 6 Avaya P130 CLI

Set port name Command

Use the set port name command to configure a name for a port. If you do not
specify a name, the port name remains empty.
The syntax for this command is:
set port name <mod_num>/<port_num> [<name>]
mod_num
port_num
<name>
Example:
P130-1# set port name 1/21 arthur
Port 1/21 name set.

Set port trap Command

Use the set port trap command to enable/disable generic SNMP uplink /
downlink traps from a port.
The syntax for this command is:
set port trap <mod_num>/<port_num> {enable | disable}
mod_num
port_num
enable
disable
Example:
P130# set port trap 1/21 enable
Port 1/21 up/down trap enabled.
76
Module number
Number of the port on the module
Name assigned to the port.
Module number
Number of the port on the module
Enables generic SNMP uplink/downlink traps from a port
Disables generic SNMP uplink/downlink traps from a port
Avaya P130 User's Guide