Verifying The Acl Configuration - Alcatel-Lucent OmniSwitch 6800 Series Network Configuration Manual

Verifying the ACL Configuration

Note that if a flag is specified on the command line after the any or all keyword, then the match value is
one. If the flag only appears as part of the mask, then the match value is zero. See the
tcpflags command page in the OmniSwitch CLI Reference Guide for more information.
Verifying the ACL Configuration
To display information about ACLs, use the same show commands that are used for displaying any QoS
policies. These commands include:
show policy condition
show policy action
show policy rule
show active policy rule
show qos config
When a show command is used to display output for all pending and applied policy configuration, the
following characters may appear in the display:
character definition
+ Indicates that the policy rule has been modified or has
been created since the last qos apply.
- Indicates the policy object is pending deletion.
# Indicates that the policy object differs between the pend-
ing/applied objects.
The following example shows all policy rules configured on the switch:
-> show policy rule
my_rule
Cnd/Act:
+my_rule5
Cnd/Act:
mac1
Cnd/Act:
The display indicates that my_rule is active and is used to classify traffic on the switch (the Act field
displays Yes). The rule my_rule5 has been configured since the last qos apply command was entered, as
indicated by the plus (+) sign. The rule will not be used to classify traffic until the next qos apply. The
rule mac1 is not active, as indicated by the No in the Act field.
page 31-20
Displays information about all pending and applied policy conditions or
a particular policy condition configured on the switch. Use the applied
keyword to display information about applied conditions only.
Displays information about all pending and applied policy actions or a
particular policy action configured on the switch. Use the applied key-
word to display information about applied actions only.
Displays information about all pending and applied policy rules or a par-
ticular policy rule.
Displays the pending and applied policy rules that are active (enabled)
on the switch.
Displays global QoS configuration parameters.
Policy From Prec
cli
cond5 -> action2
cli
cond2 -> pri2
cli
dmac1 -> pri2
OmniSwitch 6800/6850/9000 Network Configuration Guide
Enab Act Refl Log Trap Save
0 Yes Yes No
0 Yes No No
0 Yes No No
Configuring ACLs
policy condition
No Yes Yes
No Yes Yes
No Yes Yes
March 2008