Alcatel-Lucent OmniSwitch 6800 Series Network Configuration Manual page 538

AVLAN Configuration Overview
6
Enable authentication by specifying the authentication mode (single mode or multiple mode) and the
server. Use the RADIUS or LDAP server name(s) configured in step 5. For example:
-> aaa authentication vlan single-mode rad1 rad2
7
Set up an accounting server (for RADIUS or LDAP) for authentication sessions.
-> aaa accounting vlan rad3 local
Note. Verify the authentication server configuration by entering the
command or verify the accounting server configuration by entering the
command. For example:
-> show aaa authentication vlan
All authenticated vlans
1rst authentication server = rad1,
2nd authentication server
-> show aaa accounting vlan
All authenticated vlans
1rst authentication server = rad3,
2nd authentication server
For more information about these commands, see the OmniSwitch CLI Reference Guide.
page 26-6
= ldap2
= local
OmniSwitch 6800/6850/9000 Network Configuration Guide
Configuring Authenticated VLANs
show aaa authentication vlan
show aaa accounting vlan
March 2008