Alcatel-Lucent OmniSwitch 6800 Series Network Configuration Manual page 291

Hide thumbs Also See for OmniSwitch 6800 Series:
Table of Contents

Advertisement

Configuring 802.1Q
The following steps apply to Switch 2. They will attach port 2/1 to VLAN 2 and set the port to accept
802.1Q tagged traffic only:
1
Create VLAN 2 by entering vlan 2 as shown below (VLAN 1 is the default VLAN for the switch):
-> vlan 2
2
Set port 2/1 as a tagged port and assign it to VLAN 2 by entering the following:
-> vlan 2 802.1q 2/1
3
Set port 2/1 to accept only tagged traffic by entering the following:
-> vlan 802.1q 2/1 frame type tagged
4
Check the configuration by using the
-> show 802.1q 2/1
Acceptable Frame Type
Force Tag Internal
Tagged VLANS
-------------+-------------------------------------------------+
2
Connecting Switch 2 and Stack 3 Using 802.1Q
The following steps apply to Switch 2. They will attach ports 3/1 and 3/2 as link aggregation group 5 to
VLAN 3.
1
Configure static aggregate VLAN 5 by entering the following:
-> static linkagg 5 size 2
2
Assign ports 3/1 and 3/2 to static aggregate VLAN 5 by entering the following two commands:
-> static agg 3/1 agg num 5
-> static agg 3/2 agg num 5
3
Create VLAN 3 by entering the following:
-> vlan 3
4
Configure 802.1Q tagging with a tagging ID of 3 on link aggregation group 5 (on VLAN 3) by enter-
ing vlan 3 802.1q 5 as shown below:
-> vlan 3 802.1q 5
5
Check the configuration by using the
-> show 802.1q 5
Tagged VLANS
-------------+-------------------------------------------------+
3
OmniSwitch 6800/6850/9000 Network Configuration Guide
show 802.1q
:
tagged only
:
Internal Description
TAG PORT 2/1 VLAN 2
show 802.1q
Internal Description
TAG AGGREGATE 5 VLAN 3
command, as follows:
NA
command as follows:
March 2008
Application Example
page 15-9

Advertisement

Table of Contents
loading

This manual is also suitable for:

Omniswitch 6850 seriesOmniswitch 9000 series

Table of Contents