Verifying The Aclman Configuration; Using Alcatel-Lucent Cli To Display Aclman Policies - Alcatel-Lucent OmniSwitch 6800 Series Network Configuration Manual

Verifying the ACLMAN Configuration

Verifying the ACLMAN Configuration
To display information about ACLs configured through ACLMAN, use the following show commands in
the Privileged Exec Mode. Note that these commands are specific to the ACLMAN shell interface and are
not available through the Alcatel-Lucent CLI interface.
show [ip] access-lists
show ip interface
show running-config
show time-range

Using Alcatel-Lucent CLI to Display ACLMAN Policies

To display information about ACLMAN configured ACLs from the Alcatel-Lucent CLI, use the same
show commands that are used for displaying Alcatel-Lucent QoS policies. These commands include:
show policy condition
show policy action
show policy rule
show active policy rule
show qos config
When a show command is used to display output for all pending and applied policy configuration, the
following characters may appear in the display:
character definition
+ Indicates that the policy rule has been modified or has
been created since the last qos apply.
- Indicates the policy object is pending deletion.
# Indicates that the policy object differs between the pend-
ing/applied objects.
page 28-22
Displays access list configuration information.
Displays a list of ACLs associated with a specific interface.
Displays the entire ACLMAN running configuration.
Displays time range parameter values.
Displays information about all pending and applied policy conditions or
a particular policy condition configured on the switch. Use the applied
keyword to display information about applied conditions only.
Displays information about all pending and applied policy actions or a
particular policy action configured on the switch. Use the applied key-
word to display information about applied actions only.
Displays information about all pending and applied policy rules or a par-
ticular policy rule.
Displays the pending and applied policy rules that are active (enabled)
on the switch.
Displays global QoS configuration parameters.
OmniSwitch 6800/6850/9000 Network Configuration Guide
Using ACL Manager
March 2008