Alcatel-Lucent OmniSwitch 6800 Series Network Configuration Manual page 45

Managing Source Learning
1
Create VLAN 200, if it does not already exist, using the following command:
-> vlan 200
2
Assign switch ports 2 through 5 on slot 3 to VLAN 200–if they are not already associated with VLAN
200–using the following command:
-> vlan 200 port default 3/2-5
3
Create a static MAC address entry using the following command to assign address 002D95:5BF30E to
port 3/4 associated with VLAN 200 and to specify a permanent management status for the static address:
-> mac-address-table permanent 00:2d:95:5B:F3:0E 3/4 200
4
Change the MAC address aging time to 1200 seconds (the default is 300 seconds) using the following
command:
-> mac-address-table aging-time 1200
Note. Optional. To verify the static MAC address configuration, enter show mac-address-table. For
example:
-> show mac-address-table
Legend: Mac Address: * = address not valid
Vlan Mac Address
------+-------------------+--------------+-----------+------------+-----------
1 00:00:00:00:00:01
1 00:d0:95:6a:73:9a
200 00:2d:95:5b:f3:0e
Total number of Valid MAC addresses above = 3
To verify the new aging time value, enter show mac-address-table aging-time. For example,
-> show mac-address-table aging-time
Mac Address Aging Time (seconds) = 300
OmniSwitch 6800/6850/9000 Network Configuration Guide
Type Protocol
learned 0800
learned aaaa0003
delontimeout 0
March 2008
Sample MAC Address Table Configuration
Operation Interface
bridging
bridging 10/23
bridging
8/1
3/4
page 1-3