Configuring Server Load Balancing
Configuring a Windows 2000 Server
Follow the steps below to associate a loopback interface on a Windows NT server.
Note. This procedure assumes that your Windows 2000 workstation already has the Microsoft loopback
adapter installed. If this driver has not been installed, please perform the steps in
Adapter Driver to a Windows 2000 Server" on page 34-17
1
Open the Control Panel window by clicking the Start button and then selecting Settings.
2
Double-click the Network and Dial-up Connections icon in the Control Panel window.
3
Right-click the Microsoft Loopback Adapter icon in the Network and Dial-up Connections
window.
OmniSwitch 6800/6850/9000 Network Configuration Guide
Configuring the Server Farm
"Adding the Loopback
before proceeding.
Double click the "Network
and Dial-Up Connections"
icon.
Right-click the "Network
Loopback Adapter" icon.
March 2008
page 34-13