Configuring IP Multicast Switching
Configuring the IGMP Version
To change the IGMP protocol version on the system if no VLAN is specified, use the
ip multicast version
-> ip multicast version 3
You can also change the IGMP protocol version on the specified VLAN by entering:
-> ip multicast vlan 5 version 1
Restoring the IGMP Version
To restore the IGMP protocol version to its default (i.e., IGMPv2) version on the system if no VLAN is
specified, use the
ip multicast version
-> ip multicast version 0
Or, as an alternative, enter:
-> ip multicast version
To restore the IGMP version to its default version.
You can also restore the IGMP protocol version to version 2 on the specified VLAN by entering:
-> ip multicast vlan 2 version 0
Or, as an alternative, enter:
-> ip multicast vlan 2 version
To restore the IGMP version to its default version.
Configuring and Removing an IGMP Static Neighbor
IGMP static neighbor ports receive all multicast streams on the designated VLAN and also receive IGMP
reports for the VLAN. The following subsections describe how to configure and remove a IGMP static
neighbor port by using the
Configuring an IGMP Static Neighbor
You can configure a port as an IGMP static neighbor port by entering
followed by vlan, a space, VLAN number (which must be between 0 and 4095), a space, followed by
port, a space, the slot number of the port, a slash (/), and the port number.
For example, to configure port 10 in slot 4 with designated VLAN 2 as an IGMP static neighbor you
would enter:
-> ip multicast static-neighbor vlan 2 port 4/10
You can also configure a link aggregation group as an IGMP static neighbor port by entering
ip multicast static-neighbor followed by vlan, a space, VLAN number (which must be between 0 and
4095), a space, followed by port, a space, and the link aggregation group number.
For example, to configure link aggregation group 7 with designated VLAN 2 as a static neighbor you
would enter:
-> ip multicast static-neighbor vlan 2 port 7
OmniSwitch 6800/6850/9000 Network Configuration Guide
command as shown below:
command as shown below:
ip multicast static-neighbor
Configuring IPMS on a Switch
command.
ip multicast static-neighbor
March 2008
page 32-11