Ascii-File-Only Syntax - Alcatel-Lucent OmniSwitch 6800 Series Network Configuration Manual

Creating Policies
Note. (Optional) To verify that the rule has been configured, use the show policy rule command. The
display is similar to the following:
-> show policy rule
Policy
r1
(L2/3):
r2
(L2/3):
+r3
(L2/3):
This command displays information about whether or not the indicated parameter may be used to classify
traffic based on policies that are configured on the switch. For more information about this display, see
"Verifying Policy Configuration" on page
An example of how the example configuration commands might display when entered sequentially on the
command line is given here:
-> policy condition cond3 source ip 10.10.2.3
-> policy action action2 priority 7
-> policy rule my_rule condition cond3 action action2
-> qos apply

ASCII-File-Only Syntax

When the policy rule, policy condition, and policy action commands as well as any of the condition
group commands are configured and saved in an ASCII file (typically through the snapshot command),
the commands included in the file will include syntax indicating the command's origin. The origin speci-
fies where the rule, condition, condition group, or action was created, either an LDAP server or the CLI
(from ldap or from cli). For built-in QoS objects, the syntax displays as from blt. For example:
-> policy action A2 from ldap disposition accept
The from option is configurable (for LDAP or CLI only) on the command line; however, it is not recom-
mended that a QoS object's origin be modified. The blt keyword indicates built-in; this keyword cannot be
used on the command line. For information about built-in policies and QoS groups, see
Used" on page 30-4.
page 30-32
From Prec Enab
cli
cond1 -> action1
cli
cond2 -> action4
cli
cond3 -> action2
30-38.
OmniSwitch 6800/6850/9000 Network Configuration Guide
Act Refl Log Trap Save
0 Yes Yes No No
0 Yes Yes No No
0 Yes Yes No No
Configuring QoS
Yes Yes
Yes Yes
Yes Yes
"How Policies Are
March 2008