ACLMAN Modes and Commands
Access List Configuration Mode Commands
The ip-access-list command (Global Configuration Mode) invokes the Access List Configuration Mode
for the specified named ACL. The following commands are available in this mode:
Command
[sequence number] {permit | deny}
{source source-wildcard | host address |
any}
no [sequence number]
no {permit | deny} source [source-wildcard]
page 28-12
Description
Creates an ACL entry for the active named standard
ACL. The optional sequence number parameter specifies
the number assigned to the entry. If a number is not spec-
ified with this command, the next available number is
used.
Repeat this command for each additional entry that you
want to add to the active named ACL.
Use the no forms of this command to remove the speci-
fied ACL entries.
Examples:
permit any
permit 10.0.0.0 0.255.255.255
deny host 198.172.10.2
no permit any
OmniSwitch 6800/6850/9000 Network Configuration Guide
Using ACL Manager
March 2008