Alcatel-Lucent OmniSwitch 6800 Series Network Configuration Manual page 649

Configuring QoS
recognize 802.1p bits. A policy condition (Traffic) is then created to classify traffic containing 802.1p bits
set to 4 and destined for port 2 on slot 3. The policy action (SetBits) specifies that the bits will be reset to
7 when the traffic egresses the switch. A policy rule called Rule2 puts the condition and the action
together.
-> qos port 3/2 trusted
-> policy condition Traffic destination port 3/2 802.1p 4
-> policy action SetBits 802.1p 7
-> policy rule Rule2 condition Traffic action SetBits
To activate the configuration, enter the qos apply command. For more information about the qos apply
command, see "Applying the Configuration" on page
For actions that set 802.1p bits, note that a limited set of policy conditions are supported. For information
about which conditions may be used with an 802.1p action, see
and "Action Combinations" on page
Note. 802.1p mapping may also be set for Layer 3 traffic, which typically has the 802.1p bits set to zero.
OmniSwitch 6800/6850/9000 Network Configuration Guide
30-54.
30-8.
March 2008
QoS Ports and Queues
"Condition Combinations" on page 30-6
page 30-29