Verifying The Snmp Configuration - Alcatel-Lucent OmniSwitch 6850-48 Management Manual

Verifying the SNMP Configuration

Verifying the SNMP Configuration
To display information about SNMP management stations, trap management, community strings, and
security, use the show commands listed in the following table.
show snmp station
show snmp community map
show snmp security
show snmp statistics
show snmp mib family
show snmp trap replay
show snmp trap filter
show snmp authentication trap
show snmp trap config
For more information about the resulting displays from these commands, see the OmniSwitch CLI Refer-
ence Guide.
page 3-62
Displays current SNMP station information including IP address, UDP
Port number, Enabled/Disabled status, SNMP version, and user account
names.
Shows the local community strings database including status, commu-
nity string text, and user account name.
Displays current SNMP security status.
Displays SNMP statistics. Each MIB object is listed along with its
status.
Displays SNMP MIB information. Information includes MIP ID num-
ber, MIB table name, and command family.
Displays SNMP trap replay information. This includes the IP address of
the SNMP station manager that replayed each trap and the number of
the oldest replayed trap.
Displays the current SNMP trap filter status. This includes the IP
address of the SNMP station that recorded the traps and the identifica-
tion list for the traps being filtered.
Displays the current authentication failure trap forwarding status (i.e.,
enable or disable).
Displays SNMP trap information including trap ID numbers, trap
names, command families, and absorption rate. This command also dis-
plays the Enabled/Disabled status of SNMP absorption and the Traps to
WebView service.
OmniSwitch AOS Release 6 Switch Management Guide
Using SNMP
September 2009