Restoring The Mld Version 1; Configuring And Removing An Mld Static Neighbor; Configuring An Mld Static Neighbor - Alcatel-Lucent OmniSwitch 6800 Series Network Configuration Manual

Hide thumbs Also See for OmniSwitch 6800 Series:

Table of Contents

Configuring IP Multicast Switching

Restoring the MLD Version 1

To restore the MLD version to Version 1 (MLDv1) on the system if no VLAN is specified, use the

ipv6 multicast version

-> ipv6 multicast version 0

Or, as an alternative, enter:

-> ipv6 multicast version

To restore the MLD version to Version 1.

You can also restore the MLD version to Version 1 (MLDv1) on the specified VLAN by entering:

-> ipv6 multicast vlan 2 version 0

Or, as an alternative, enter:

-> ipv6 multicast vlan 2 version

To restore the MLD version to Version 1.

MLD static neighbor ports receive all multicast streams on the designated VLAN and also receive MLD

reports for the VLAN. The following subsections describe how to configure and remove a static neighbor

port by using the

ipv6 multicast static-neighbor

You can configure a port as an MLD static neighbor port by entering

followed by vlan, a space, VLAN number (which must be between 0 and 4095), a space, followed by

port, a space, the slot number of the port, a slash (/), and the port number.

For example, to configure port 10 in slot 4 with designated VLAN 2 as an MLD static neighbor you would

-> ipv6 multicast static-neighbor vlan 2 port 4/10

You can also configure a link aggregation group as an MLD static neighbor port by entering

ipv6 multicast static-neighbor followed by vlan, a space, VLAN number (which must be between 0 and

4095), a space, followed by port, a space, and the link aggregation group number.

For example, to configure link aggregation group 7 with designated VLAN 2 as a static neighbor you

would enter:

-> ipv6 multicast static-neighbor vlan 2 port 7

OmniSwitch 6800/6850/9000 Network Configuration Guide

command by entering:

ipv6 multicast static-neighbor

Configuring IPMSv6 on a Switch