Enabling The Mld Zapping; Disabling The Mld Zapping - Alcatel-Lucent OmniSwitch 6800 Series Network Configuration Manual

Modifying IPMSv6 Parameters
between IP multicast groups.) is disabled on a switch. The following subsections describe how to enable
and disable zapping by using the

Enabling the MLD Zapping

To enable MLD zapping on the system if no VLAN is specified, use the
command as shown below:
-> ipv6 multicast zapping enable
You can also enable MLD zapping on the specified VLAN by entering:
-> ipv6 multicast vlan 2 zapping enable

Disabling the MLD Zapping

To disable MLD zapping on the system if no VLAN is specified, use the
command as shown below:
-> ipv6 multicast zapping disable
Or, as an alternative, enter:
-> ipv6 multicast zapping
To restore the MLD zapping to its default setting (i.e., disabled).
You can also disable MLD zapping on the specified VLAN by entering:
-> ipv6 multicast vlan 2 zapping disable
Or, as an alternative, enter:
-> ipv6 multicast vlan 2 zapping
To restore the MLD zapping to its default setting (i.e., disabled).
page 32-34
ipv6 multicast zapping
OmniSwitch 6800/6850/9000 Network Configuration Guide
Configuring IP Multicast Switching
command.
ipv6 multicast zapping
ipv6 multicast zapping
March 2008